1.Daily inspection and maintenance of the wood pellet machine roller
The roller is checked regularly
The wood pellet machine roller is inspected once a month, including the rotation flexibility and wear of the moving parts of the biomass pellet machine roller cover, wood pellet machine roller bearings, bolts on the lubricating block, etc. Defects found should be repaired in time, not forced to use.
The biomass pellet machine press roller checks the transmission components
When the biomass pellet machine is working, if it is found that the temperature of the reducer oil rises more than 80 °C or the oil pool temperature exceeds 100 ° C and produces abnormal noise, it should be stopped, check the cause, replace the lubricating oil and eliminate the fault before it can continue to operate.

2. Clean and lubricate the wood pellet machine roller
biomass pellet machine roller cleaning
After the machine is used or stopped, the rotating drum should be removed for cleaning and brushing the remaining powder in the bucket, and then installed to prepare for the next use.
Biomass pellet press roller lubrication
The press wheel extruded wood chips and other raw materials into the inner hole of the ring die, and pushed the back raw materials to the front raw materials to achieve the purpose of final ring die. Therefore, the working temperature of the pressure wheel is very high, and timely and reasonable oil supply and heat loss can effectively extend the service life of the pressure wheel and increase the working output of the effective time of the pressure wheel.
3. Biomass pellet press roller storage and protection
Biomass pellet machine press roller storage environment
As the core and key parts of the pellet machine, the wood pellet machine ring die and the press roller must be maintained daily to ensure that the wood pellet machine runs in a high efficiency state. When the wood pellet machine ring die is stored for more than half a year, the oil in the ring die needs to be replaced. Too long a storage period will make the oil harden and difficult to remove, which has a negative impact on the use of the wood pellet machine ring die. Store the pellet machine ring die regularly in a ventilated and dry place. Any ring die will corrode if kept in a damp place. Wood chips filled on the ring die absorb and retain moisture, speeding up the corrosion process, reducing die life and resulting in slow production efficiency.
Protective measures for wood pellet machine press roller
If the time is long, the whole body of the machine must be wiped clean, the smooth surface of the machine is coated with anti-rust oil, and the cloth cover is good.
4. Press roller special operation skills
After the new wood pellet machine or the replacement of a new ring die press wheel, it is fully and reasonably ground before formal use. The ring die press wheel of the wood pellet machine is a heat treatment part. During the heat treatment process, some burrs are produced in the inner hole of the ring die, which will hinder the flow and forming of the material in the pressing of the wood pellet.
The biomass pellet machine press roller adjusts the clearance
Adjust the M10 screw on the front bearing shank to the proper position when the roller moves back and forth during operation. If the gear shaft moves, please adjust the M10 screw behind the bearing frame to the appropriate position, adjust the clearance so that the bearing does not make a noise, hand turn the pulley, the appropriate tightness is appropriate, too tight or too loose can make the machine may be damaged.
Through the above maintenance tips and tricks, the service life of the biomass pellet machine roller can be effectively extended to ensure the continuity and efficiency of production.